Auto-Tie Horizontal
Model AT-1086-100S
Revised: 12/99
HYDRAULIC
Main Pumps 298 GPM Total Flow (Regen. System)
System Pressure 3200 PSI
Main Cylinder 10 In Bore, 100 In Stroke
Tension Cylinder (6) 6 In Bore
Wire Inserter Cylinder 2 1/2 In Bore
Wire Twister Hydraulic Motor
Total Force 251,200 Lb
Ram Face Pressure 136 PSI
Oil Reservoir 600 Gallon Capacity
Filtration 7 Micron Replacement Element Filter
Auto-Tier (5) Five Wire Hydraulic Tier for up to 10 GA
Black Annealed Wire
ELECTRICAL
Main Motor 100 HP, 460 Volt, 3 Phase, ODP, Special Duty, Wye Delta Starting
Cooler Fan 3 HP, 460 Volt
Cooler Pump 7.5 HP, 460 Volt
Controls Programmable Controller with Phone Modem
Photocell Infrared Type
STRUCTURAL
Length Overall 40 Ft 3 In (with power pack located behind baler)
36 Ft 3 In (with power pack located beside baler)
Width Overall 15 Ft 3 In (at the tier station)
Charging Hopper Ht. 98 In
Charge Box Opening 40.5 In Wide x 80 In Long
Shear Blade T-1 Alloy Steel, Serrated
Floor of Baler is Long Wearing T-1 Plate, Bottom of Platen is T-1 Plate
Shipping Weight 29 Tons Approximate
PERFORMANCE
Bale Size expanded 43 In Wide x 43 In High x Variable Length
Bale Volume @ 62 In Long 66.3 Cubic Feet Expanded (Approximate)
Cycle Time 9 Seconds (No Load)
Capacity 39,300 Cubic Feet per Hour (No Load)
|
Material |
Bale Weight LB |
Density LB Per Cubic Foot |
Loose Infeed Density Pound Per Cubic Foot |
Tons Per Hour @65% Loading Efficiency |
|
High Grade Paper |
up to 2300 |
up to 35 |
Estimated 3.5 |
up to 40 |
|
News |
up to 2100 |
up to 32 |
Estimated 3.0 |
up to 35 |
|
O.C.C. |
up to 2000 |
up to 30 |
Estimated 2.5 |
up to 25 |
*Performance Rates, Bale Weights, and Bale Densities Are Subject to Moisture Content, Material Pre-Bale Densities, Feed Rates, And Other Variables in Baling
STANDARD FEATURES AVAILABLE OPTIONS
Programmable Controller with Model Material Fluffer
Oil Cooler (air over oil) System Mid Tension System
Wye Delta Starting Precompression Lid
Bale Runout Table (6 Ft Long) Contact Factory for other Available Options